Welcome 

This set of instructions is designed to assist you in the building of an adapted plate switch.

Some basic assumptions need to be made before we continue:

1. You are able to use a screw driver.

2. You can (or know someone who can) operate  a power drill.

3. You have some experience with soldering (hopefully positive).

4. You are responsible for the outcome of this process.  Returning the parts once you have soldered and drilled holes in them may be difficult - if not impossible.

If you are ready to continue select Introduction or Parts and Tools below to get started.

Good luck!

We are only building the Switch not the alligator.